Cutting: A hacksaw is recommended to cut trade sizes 1-1/4 and smaller. Larger trade sizes can be cut with power cut-off equipment.
Bending: Standard EMT benders, one size larger than the size of the conduit, should be used on conduit trade sizes 1 and smaller. For sizes over trade size 1, conventional equipment is recommended.
Threading: Sharp dies and conventional cutting oil should be used for aluminum conduit. A general purpose emulsifiable oil can provide excellent results.
Fittings: Aluminum fittings are recommended; however, cadmium plated or galvanized fittings are satisfactory for most installations.
Fishing and Wire Pulling
Small Conduit: In trade sizes up to 1-1/2 and on shorter runs (up to 100 feet), polyethylene fish tapes can be used effectively. Also recommended are round, flexible, speedometer-type steel cables. Use of flat steel tapes should be avoided since they tend to jam in the bends, or if not used carefully, scrape and cut conduit walls.
Large Conduit: For pulling large conductors through larger conduit or longer runs, polypropylene rope is recommended. Steel pulling cables, especially when old or frayed, can damage steel or aluminum conduit.
In Soil or Concrete: The Canadian Electrical Code states that aluminum conduit and tubing shall not be embedded in concrete containing reinforcing steel unless the concrete contains no chloride additives or the conduit/tubing has been treated with supplementary corrosion protection.